User's Manual

P1D Wireless Broadband Modem User Manual
- Page 5 of 46 -
Section 1 – Introduction
Before using your Wireless Broadband Modem for the first time, please read and follow all
warnings, safety, care, cleaning and operating instructions on the Wireless Broadband Modem
label and in this guide. These guidelines will help protect your Wireless Broadband Modem
from potential damage and ensure your personal safety.
Safety Guidelines for Power Connection
Danger - Do not place or use the P1D Wireless Broadband Modem near any body of water.
Accidental immersion can result in electric shock.
Danger - Never alter the AC adapter or plug. If the plug will not fit into the electrical outlet
without force, contact a qualified electrician to install a proper outlet.
Connect the AC adapter to 120V or 230V electrical outlets only.
To disconnect the unit from mains power, remove the AC adapter from the wall socket.
To reduce the risk of damage, always remove each end of the power cable by pulling the plug
rather than the cable.
Do not allow anything to rest on the power cable.
Do not position the power cable in any area where people will step on it.
Do not use the P1D Modem if the power cable becomes frayed or damaged in any way.
Do not overload the power outlet. Power overloads are often caused by too many electrical
devices connected by extension cords and can result in electric shock or fire.
See Appendix B for important safety information about the internal battery.
Safety Guidelines for the P1D Wireless Broadband Modem
Do not attempt to disassemble the Wireless Broadband Modem; doing so may expose you to
unsafe conditions. The Wireless Broadband Modem does not contain consumer serviceable
components. Service should be performed by the Service Provider Service Center only.
Contact Service Provider Customer Service to find the nearest Service Centre.
Position the Wireless Broadband Modem so that it is protected from falling objects.
Do not allow liquids to spill on or into the Wireless Broadband Modem.
Do not expose the Wireless Broadband Modem to extreme heat (over 131° F/+55°C) or cold
(under 14° F/-10°C) temperatures.
Do not leave the Wireless Broadband Modem in a motor vehicle parked in direct sunlight for
more than fifteen minutes.