User Manual

IPWireless Broadband Modem User Guide
12
Chapter 3 – Installation and Registration
This chapter explains how to install the software, register your user information, and
operate your IPWireless Broadband Modem. The instructions explain how to:
Support the IPWireless Broadband Modem using the built-in stand.
Connect the AC Power Adapter
Find the Best Radio Signal
Install the IPWireless PC Software
Cable Connection between the Modem and the Computer
Perform Registration
Support the IPWireless Broadband Modem Using the Built-in Stand
On the lower back panel of the IPWireless Broadband Modem is a removable
battery cover, which incorporates a stand that supports the IPWireless Broadband
Modem. Complete the following steps to support the IPWireless Broadband Modem
using the built-in stand:
1. Insert your index finger into the slot at the top of the battery cover.
2. Gently pull the stand toward you until it locks in position. See Figure 2
below.
3. Set the IPWireless Broadband Modem on a flat surface, such as a desk or
windowsill, but avoid direct sunlight.
Figure 2