User's Manual

[IPWireless] Broadband Modem User Guide – Draft v.3
15
Chapter 3 – Installation and Registration
This chapter explains how to install the software, register your user information, and
operate your [IPWireless] Broadband Modem. The instructions explain how to:
o Support the [IPWireless] Broadband Modem using the built-in stand.
o Plug the power cable into the [IPWireless] Broadband Modem and AC power
outlet.
o Connect the computer interface cable between the computer and the
[IPWireless] Broadband Modem.
o Position the [IPWireless] Broadband Modem in an area that provides the best
radio signal.
o Install the [IPWireless] PC Software from the CD.
o Configure your [IPWireless] Broadband Modem on your PC.
o Register your user information on the [IPWireless] web site.
o Connect to the Internet.
Support the [IPWireless] Broadband Modem Using the Stand
On the lower back panel of the [IPWireless] Broadband Modem is a removable
battery cover, which incorporates a stand that supports the [IPWireless] Broadband
Modem. Complete the following steps to support the [IPWireless] Broadband
Modem using the built-in stand:
1. Insert your index finger into the slot at the top of the battery cover.
2. Gently pull the stand toward you until it locks in position. See Figure 2
below.
3. Set the [IPWireless] Broadband Modem on a flat surface, such as a desk or
windowsill, but avoid direct sunlight.
Figure 2
Connect the AC Power Adapter
1. Plug the pin end of the power cable into the DC power jack located on the
side of the [IPWireless] Broadband Modem as shown in Figure 3 below.