Full Product Manual

16 Owner’s Manual for Tow-Behind Field and Brush Mower
Operation
4. See Figure 3-10. Remove clevis pin and hair pin
with washer (F) securing tow bar extension.
Figure 3-10. Offsetting the Tow Bar Extension
5. Rotate tow bar extension from no offset to medium
offset (G) or full offset (H).
IMPORTANT NOTE: See Figure 3-11. Tow bar offset
angle (I) and tow bar extension offset angle (J) must
match to ensure proper tracking.
Figure 3-11. Full Offset
6. Reinstall clevis pin and hair pin with washer.
Changing Tow Bar Offset Direction
1. See Figure 3-12. Remove blade engage/disen-
gage control (A) from connector (B).
Figure 3-12. Blade Engage/Disengage Remote
Control
2. See Figure 3-13. Remove remote control cable (A)
from cable clamps (B).
Figure 3-13. Remote Control Cable and Clamps
3. Remove cable clamps with 5/16" nut driver.
4. See Figure 3-14. Support tow bar while removing
clevis pin and hair pin with washer (C).
Figure 3-14. Offset Bracket for Right Side Offset
5. See Figure 3-15. Turn offset bracket over and rein-
stall with clevis pin and hair pin with washer.
Figure 3-15. Offset Bracket for Left Side Offset
6. Install cable clamps to top of tow bar with a 5/16"
nut driver.
7. Route remote control cable through bar cable clamps.
8. Plug blade engage/disengage remote control onto
connector.
9. Set tow bar and tow bar extension to the desired
offset. See Offset Mowing for instructions on
adjusting tow bar and tow bar extension offset.
005921
H
G
F
005919
I
J
005871
B
A
A
B
005872
005869
C
005922