Full Product Manual

Owner’s Manual for Tow-Behind Field and Brush Mower 7
General Information and Setup
Installing Hitch
1. See Figure 2-4 . Attach chain connector (A) to the
end of each safety chain (B) with the shorter side (C)
toward the safety chain. Tighten with 10 mm wrench.
Figure 2-4. Chain Connector
2. See Figure 2-5. Place receiver (D) on extension
(E).
Figure 2-5. Receiver and Ball Hitch Extension
3. Loosely secure the front of the receiver with 1/2-13
x 5" bolt with washer and locknut with washer (F).
4. Loosely secure the rear of the receiver and safety
chains with 1/2-13 x 5" bolt with washer and lock-
nut with washer (G) with washers between safety
chain.
5. Tighten front and rear bolts using two 3/4”
wrenches.
6. See Figure 2-6. Install ball hitch extension (K) to
tow bar with pivot bolt and locknut (L).
Figure 2-6. Receiver and Ball Hitch Extension
7. Install clevis pin and hair pin with washer (M).
Connecting Remote Control
1. Cut cable tie securing remote control cable to
frame.
2. See Figure 2-7. Remove blade engage/disengage
remote control (A) from connector (B).
Figure 2-7. Remote Control
3. See Figure 2-8. Route remote control cable (C)
through tow bar cable clamps (D).
Figure 2-8. Remote Control Installed
4. Plug remote control onto connector.
006210
A
B
C
006211
D
E
F
G
006213
M
L
K
(000449)
Personal injury. Install clevis pins from the bottom with the
washers and hair pins on top. Failure to do so could
result in death, serious injury, equipment or property
damage.
WARNING
005871
A
B
005872
D
C