Replacement Part List

ManualsBrandsGenerac ManualsBox Scrapers60 in. 12-Volt Battery-Powered Power Grader with Remote, 9 Ah Battery and Charger Included

Owner’s Manual for Power Grader 15

Operation

Adjusting Mold Board

Adjusting Mold Board Angle

The mold board can be adjusted to three different angles

to provide for varying degrees of aggressiveness.

See Figure 3-5. Set the mold board at rearmost hole (A)

for aggressive grading. Use forward positions (B) for a

smoother surface.

Figure 3-5. Adjusting Mold Board Angle

To adjust mold board angle:

1. See Figure 3-5. Remove top bolt and locknut (A)

on both mold board ends using two 9/16"

wrenches.

2. Loosen bottom bolt and locknut (C) using two 9/16"

wrenches so mold board can be rotated.

3. Align mold board hole (A) with hole at desired

angle setting (B).

4. Reinstall top bolts and locknuts and tighten all

hardware.

Converting Mold Board to Smooth or Grooved

Edge

•

The mold board can be mounted with straight edge

down for basic grading or for creating smoother

surfaces in finer materials.

• The mold board can be mounted with grooved

edge down for aggressive grading or for creating

grooved surfaces in finer material.

Proceed as follows to convert molding board from one

edge to the other.

1. See Figure 3-6. Remove bolts and locknuts (A)

securing both mold board ends to power grader

frame using two 9/16" wrenches.

Figure 3-6. Converting Mold Board Edge

2. See Figure 3-7. Remove mold board and position

with desired edge down and welded angle (B) fac-

ing the rear of the machine.

Figure 3-7. Welded Angle Facing Rear

Operating Tips

NOTE: Frequently verify the tightness of bolts fastening

tooth bar and mold bar to the frame.

• Avoid large rocks, embedded ledge, cattle guards

or similar obstructions. After each pass remove

rocks pulled to the surface.

• Verify tooth bar is in the raised position before turn-

ing around or leaving work area.

• Avoid pot holes filled with water.

• Work the edges of pot holes more than 4 ft

(1.22 m) wide to loosen sides before filling them.

• Expect to make several passes when repairing a

roadway.

• Once a road surface has been adequately scari-

fied, raise the teeth plate to allow rear scraper

blade to create a smooth surface.

006136

006138