Replacement Part List

10 Owner’s Manual for Power Grader
General Information and Setup
Installing Actuator Harness
1. See Figure 2-30. Insert actuator harness (A) into
Molex mount (B) and push to snap in place
.
Figure 2-30. Molex Mount
2. Plug extension harness (C) into actuator harness
at Molex mount.
3. Plug control box (D) onto extension harness.
4. See Figure 2-31. Route actuator harness (E) over
tow bar and under height adjustment cable (F) on
left side of unit
.
Figure 2-31. Actuator Harness Routing
5. Insert actuator harness end through grommet (G)
on left side of actuator assembly.
6. See Figure 2-32. Route actuator harness (H)
along left side of actuator (I) and under spacer (J)
.
Figure 2-32. Actuator Harness Routing
7. Continue routing harness until there is no slack at
tow bar.
8. See Figure 2-33. Connect two actuator plugs (K)
to harness.
Figure 2-33. Actuator Plugs
9. Connect the red positive (+) harness wire to red
battery terminal (L).
10. Connect the black negative (-) harness wire to
black battery terminal (M).
11. Route actuator harness alongside battery.
12. See Figure 2-34. Secure harnesses to tow bar and
pitch bar with remaining cable ties (N).
Figure 2-34. Securing Harness with Cable Ties
13. Reinstall battery and secure with battery straps and
wing nuts.
14. See Figure 2-35. Replace actuator cover (O) and
tighten hand knobs (P) to secure
.
Figure 2-35. Actuator Cover and Hand Knobs
006125
A
B
C
D
006126
E
F
G
006127
I
H
J
006128
M
L
K
006129
N
006130
O
P