Replacement Part List

Owner’s Manual for Power Grader 9
General Information and Setup
6. Reinstall battery with battery strap and wing nuts.
7. See Figure 2-24. Route height adjust cables (H)
through the gaps between front crossmember and
tooth bar (I) and rear crossmember and mold
bar (J).
Figure 2-24. Actuator Assembly on Frame
8. See Figure 2-25. Pull rubber boot (K) off right
height adjust cable (L) and unscrew outer nut (M)
off threads.
Figure 2-25. Height Adjust Cable End
9. See Figure 2-26. Slide right height adjustment
cable (O) into right axle bracket hole (P) and pull
threads through.
Figure 2-26. Inserting Cable Through Axle Bracket
10. See Figure 2-27. Install outer nut (Q) and tighten
with 1/2” wrench while holding inner nut with 1/2”
wrench.
Figure 2-27. Inserting Cable Through Axle Bracket
11. Slide rubber boot (R) onto the threads.
12. See Figure 2-28. Insert 10 mm shoulder bolt (S)
through cable eyelet and into axle weldment hole
13. Secure 10mm shoulder bolt with M8 locknut with
3/8” washer using 5 mm Allen wrench and 13 mm
wrench.
Figure 2-28. Securing Height Adjust Cable to Axle
Weldment
14. Repeat steps 9 through 14 on left adjustment
cable, securing it to left axle weldment.
15. See Figure 2-29. Secure height adjust cables to
front crossmember with cable ties using the holes
provided (U).
Figure 2-29. Cable Ties
006119
H
J
I
006120
M
L
K
N
006122
P
O
006124
Q
R
006121
S
T
006123
U