Product Manual
Table Of Contents
- Section 1: Introduction and Safety
- Section 2: General Information
- Section 3: Operation
- Unit Setup
- Raising the Mast—Manual Winch
- Raising the Mast—Electric Winch (If Equipped)
- Prestart Checklist
- Starting Unit—Analog Controls
- Starting Unit—Power Zone Controls (MANUAL Mode)
- Starting Unit—Power Zone Controls (AUTO Mode)
- Operating Lights—Analog Controls
- Operating Lights—Power Zone Controls (MANUAL Mode)
- Operating Lights—Power Zone Controls (AUTO Mode)
- Shutting Down Unit—Analog Controls
- Shutting Down Unit—Power Zone Controls (MANUAL Mode)
- Shutting Down Unit—Power Zone Controls (AUTO Mode)
- Automatic Shutdown
- Starting Utility Mode (If Equipped)—Analog Controls
- Starting Utility Mode (If Equipped—Power Zone Controls
- Stopping Utility Mode (If Equipped)—Analog Controls
- Stopping Utility Mode (If Equipped)—Power Zone Controls
- Dusk-to-Dawn Sensor (If Equipped)
- Customer Convenience Receptacles (If Equipped)
- Removing Loads from Receptacles (If Equipped)
- Storing the Unit
- Lowering the Mast—Manual Winch
- Lowering the Mast—Electric Winch (If Equipped)
- Positive Air Shutdown (PAS) (If Equipped)
- Lower Radiator Hose Heater (If Equipped)
- Tandem Tow (If Equipped)
- Telemetry (If Equipped)
- Spark Arrester (If Equipped)
- Heated Fuel Filter (If Equipped)
- Towing the Unit
- Lifting the Unit
- Tying Down the Unit
- Section 4: Maintenance
- Section 5: Troubleshooting
- Section 6: Wiring Diagrams
16 Owner’s Manual for Mobile Light Tower
General Information
Component Locations
Figure 2-10. Exterior Components
A Light fixture (4 locations) J Unit lift point
B Fuel fill port K Exhaust
C Grounding stud L Outrigger jack (2 locations)
D Dawn-to-dusk sensor (behind mast) M Outrigger pin (2 locations)
E Tie-down point N Rear tie-down point (2 locations)
F Tongue jack O Fork pocket (2 locations)
G Mast rotation knob P Hood latch
H Winch Q Control panel access door
I Mast R Hood
010573
C
H
G
B
O
Q
L
K
J
R
A
P
M
I
D
E
F
E
N