Product Manual
Table Of Contents
- GP3500iO Portable Generator Owner’s Manual
- Generador portátil GP3500iO Manual del usuario
- Índice de contenidos
- Sección 1 Introducción y seguridad
- Sección 2 Información general y configuración
- Sección 3 Funcionamiento
- Preguntas sobre uso y funcionamiento
- Antes de arrancar el motor
- Preparación del generador para su uso
- Conexión a tierra del generador cuando se utiliza
- Conozca los límites del generador
- Transporte o inclinación de la unidad
- Arranque de motores con el tirador de arranque
- Volver a arrancar motores calientes
- Sistema de cierre por nivel bajo de aceite
- Funcionamiento en paralelo
- Sección 4 Mantenimiento y solución de problemas
- Pieza Nº 10000016698
- Générateur portatif GP3500iO Manuel du propriétaire
- Table des matières
- Section 1 Introduction et règles de sécurité
- Section 2 Informations générales et mise en place
- Section 3 Fonctionnement
- Questions relatives au fonctionnement
- Avant de démarrer le moteur
- Préparation du générateur à l’utilisation
- Mise à la terre du générateur une fois en fonctionnement
- Connaître les limites de son générateur
- Transport/Inclinaison de l’appareil
- Démarrage des moteurs à démarrage manuel
- Démarrage des moteurs à chaud
- Système d’arrêt en cas de faible niveau d’huile
- Fonctionnement en parallèle
- Section 4 Maintenance et dépannage
- Réf. 10000016698
Owner’s Manual for Portable Generator 13
.
Inspect Engine Oil Level
Inspect engine oil level prior to each use, or
every 8 hours of operation.
1. Place generator on a level surface.
2. Clean area around oil fill, and oil drain
plug.
3. Remove oil fill cap and wipe dipstick clean.
See Figure 4-1.
Figure 4-1. Engine Oil Fill
4. To check oil level, insert dipstick into oil
filler neck without screwing it in. See Fig-
ure 4-2.
Figure 4-2. Safe Operating Range
5. Remove dipstick and verify oil level is
within safe operating range.
6. Add recommended engine oil as neces-
sary.
NOTE: Verify oil level often during filling pro-
cess to ensure overfilling does not occur.
7. Replace oil fill cap and hand-tighten.
NOTE: Some units have more than one oil fill
location. It is only necessary to use one oil fill
point.
Change Engine Oil
When using generator under extreme, dirty,
dusty conditions, or in extremely hot weather,
change oil more frequently.
NOTE: Don’t pollute. Conserve resources.
Return used oil to collection centers.
Change oil while engine is still warm from run-
ning, as follows:
1. Place generator on a level surface.
2. Disconnect the spark plug wire from the
spark plug and place the wire where it
cannot contact spark plug.
3. Clean area around oil fill and oil drain plug.
4. Remove oil fill cap and wipe dipstick clean.
5. Tip unit and drain oil completely into a suit-
able container.
6. Once oil is sufficiently drained from unit, tip
unit back to a level position.
7. Insert funnel into oil fill opening. See Fig-
ure 4-3. Add recommended engine oil as
necessary.
Figure 4-3. Oil Fill Opening With Funnel
8. To check oil level, remove funnel and
insert dipstick into oil filler neck without
screwing it in. See Figure 4-2.
9. Remove dipstick and verify oil level is
within safe operating range.
NOTE: Verify oil level often during filling pro-
cess to ensure overfilling does not occur.
10. Replace oil fill cap and hand-tighten.
11. Wipe up any spilled oil.
12. Properly dispose of oil in accordance with
all applicable regulations.
SAE 30
10W-30
Synthetic 5W-30
000399
(000139)
WARNING
Risk of burns. Allow engine to cool before
draining oil or coolant. Failure to do so could
result in death or serious injury.
000115
005484
(000141)
WARNING
Accidental start-up. Disconnect spark plug wires when
working on unit. Failure to do so could result in death
or serious injury.
002404










