Installation Guide

Unpacking and Inspection

Installation Guidelines For Australian 50 Hz Air-Cooled Generators 9

Intake Side Panel Removal

See Figure 2-5. The intake side panel (A) must be

removed to access the battery compartment, fuel regula-

tor, and sediment trap.

1. Raise the lid and remove the front panel.

2. Use an hex key to remove two mounting screws

(B) and the L-bracket screw (C).

3. Lift the intake panel up and away from the

generator.

NOTE: Always lift the intake side panel straight up

before pulling away from enclosure. Do not pull the panel

away from the enclosure before lifting up (D).

Figure 2-5. Intake Side Panel Removal

1. Inspect for any hidden freight damage. Contact the

freight carrier if damage is present.

2. See Figure 2-6 and Figure 2-7 for customer

connections and loose parts location. Figure 2-9

illustrates parts shipped loose.

Figure 2-6. Customer Connection Area and Loose

Parts Location

Rear Connections

Figure 2-7. Rear Connections

NOTE: The generator may be equipped with a Wi-Fi

module. Refer to the Wi-Fi module owner’s manual for

further instruction.

002961

A Customer electrical connection area

(behind the access panel)

B Fuel regulator with sediment trap

C Battery compartment (battery not supplied)

D Positive (+) and negative (-) battery cables

E Location of “Loose Shipped Parts”

006151

A Wi-Fi Module (if equipped)

B Main AC/Control wiring hole for 1-1/4 in conduit

C Main AC/Control wiring hole for 3/4 in conduit

D Fuel Connection hole

006086