Installation Guide

Unpacking and Inspection

8 Installation Guidelines For Australian 50 Hz Air-Cooled Generators

6. See Figure 2-3. Remove bolts and pallet brackets

(A). Exercise caution when removing the genera-

tor. Dragging it off the pallet will damage the base.

The generator must be lifted from the wooden pal-

let to remove.

Bolts and pallet brackets are provided only for ship-

ping purposes and can be discarded after removal.

Figure 2-3. Generator on Pallet

7. See Figure 2-4. Two locks secure the lid; one on

each side (A). Press down on the lid above the side

lock, and unlock the latch to properly open the lid.

8. Repeat for the other side. The lid may appear stuck

if pressure is not applied from the top.

NOTE: Always verify the side locks are unlocked before

attempting to lift the lid.

9. Remove the front access panel by lifting it straight

up and out once the lid is open.

NOTE: Always lift the front access panel straight up

before pulling away from enclosure (B and C). Do not pull

the panel away from the enclosure before lifting up (D).

Figure 2-4. Side Lock Location and Front Panel Removal

000426

001797