Brochure
www.generac.com
PMM™ (Power Management Module) and Starter Kit
Use Generac’s Power Management Module (PMM) in conjunction with the Smart Switch™ to
intelligently manage additional large loads and enable the efcient use of a smaller generator
system. Just like the built-in load-shedding capabilities of the Smart Switch, after the load(s) are
shed, the PMM module brings them back on individually to ensure generator power availability
and eliminate potential system overload.*
• 50 Amp
• Up to four PMM Modules can be installed with each Smart Switch
• NEMA 3R enclosure allows for installation either at the electrical panel or anywhere
between the panel and the appliance, indoors or out
* PMM Starter Kit included required transformer and the rst PMM, required for PMM operation.
Cold Weather Kit
If the temperature regularly falls below 32° F, install a cold weather kit to maintain optimal
battery and engine oil temperature. Kit contains a thermostat-controlled battery pad and
engine-block warmer.
Scheduled Maintenance Kits
A scheduled maintenance program ensures the generator system is always in top operating
condition and warranty requirements are being met. Generac’s scheduled maintenance kits
provide all the hardware necessary to perform complete routine maintenance on a Generac
automatic standby generator. Oil must be purchased separately based upon manufacturer
recommendations listed below. Maintenance is recommended at every 200 hours or 2 years.
Kit contents may vary by model. Kits Include:
• Air Filter • Oil Filter
• Spark Plugs • Oil Funnel
• Chamois • Reminder Sticker
Extended Warranty
Up to ve years extended warranty coverage available through Generac Industrial and
Residential/Commercial Dealers.
For more accessories, visit Generac.com
or see the table on page 23.
19
- Greg Beappler
My FAMILy’S GOING TO bE SAFE AND SECURE
IN My HOUSE bECAUSE OF THIS GENERATOR.