Installation Guide

Control Panel Start-Up/Testing
40 Installation Guidelines For Australian 50 Hz Air-Cooled Generators
Figure 7-2. Installation Wizard Menu Map
Language
+ English -
+ Espanol -
+ Francais -
+ Portuguese -
+ ...... -
Install Wizard
Power Up Unit
Select Hour (0-23)
- 14 +
ENTER
No
Yes
ENTER
FIRMWARE V X.XX
HARDWARE V X.XX
Holding the Up or Down
arrow button for 2 seconds will speed dial through the selections
Defaults to English. Select desired language by scrolling through list.
Note: If language was previously programmed this goes directly to “Select Hour”
Use UP and DOWN arrows to select fuel type, then press “ENTER”.
*
Fuel Selection
+ NG or LP -
Follow setup
process in
Wi-Fi manual
Cold Smart Start?
Å
YES or NO
Æ
006669
Default voltage 220V. Use UP arrow to select output voltage and press ENTER.
Set Output Voltage
220, 230, 240
Use UP and DOWN arrows. to select YES or NO. Press ENTER.
Setup Wi-Fi?
+
Yes or No
-
SYSTEM WIFI
DATE/TIME
SUB MENUS
UP ARROW =
+
DOWN ARROW = -
ENTER ENTER ENTER
ENTER
ESC
ENTER
ENTER
ENTER
ENTER
*
WIFI Signal XX%

Time Zone
XXXXXX
Update From: WIFI
<Enter> to Begin
Update From Server
Continue?
Controller X.XX.XXX
Server X.XX.XXX
Install Wizard
Set Exercise...
Fuel Selection
+ NG or LP -
Set Output Voltage
220, 230, 240
Cold Smart Start?
Å
YES or NO
Æ
Exercise Time
HH:MM Day Biweekly

WIFI Signal XX%