Product Manual

Breather Heater Kit 3
2. See Figure 7. Remove three mounting screws
behind engine divider panel to disconnect snorkel
(J
).
009589
J
Figure 7. Removing the Snorkel (500/1000 Series)
3. See Figure 8. Remove screws from airbox base
(K).
009591
K
Figure 8. Removing the Airbox Screws (500/1000
Series)
4. See Figure 9. Remove screws attaching mixer to
intake manifold (access screws behind divider
pa
nel). Set airbox base and mixer (L) aside, with
wires still connected to mixer, to expose breather
hose (M).
009590
L
M
Figure 9. Removing the Mixer (500/1000 Series)
NOTE: See Figure 10. For units with the 1000 Series
engines (2016–Present), the lower mixer screw is acces-
sible through a hole (N) in the engine divider panel.
Remo
ve plastic cover from the hole and set aside for
reassembly.
009629
N
Figure 10. Access Hole in Divider Panel
5. See Figure 11. Wrap breather heater (P) around
breather hose, evenly space
d as shown, with lead
wires at the bottom. Wrap breather heater and
hose with silicone tape (provided) to secure heater.
009639
Q
P
Figure 11. Wrapping the Breather Hose (500/1000
Series)
6. Pass
lead wires through harness grommet (Q) in
the engine divider panel.
7. Secure
all wires with plastic wire ties at least 0.5 in
(1 cm) away from fuel hoses.
8. Install mixer with air box
base and snorkel.
9. Inst
all intake elbow, air filter, and air box cover.
10. Pro
ceed to Connecting Lead Wires.