Product Manual

18 Owner’s Manual for CTF10 Light Tower
Operation
3. See Figure 3-1. Pull locking pins (A) on the four
outriggers (B) and pull each out outrigger until the
locking pin snaps into stabilizer hole (C).
.
010136
A
B
C
Figure 3-1. Setting up Stabilizers (1 of 2)
4. See Figure 3-2. Rotate each jack handle (D)
clockwise to start leveling the unit, referencing
spirit level (E). Adjust all four jacks by rotating their
handles clockwise until the bottom of the unit no
longer touches the ground.
D
010131
E
Figure 3-2. Setting up Stabilizers (2 of 2)
5. See Figure 3-3. Before raising the mast, adjust the
LED fixtures by loosening handle (E) and aiming
the LED in the desired direction. After adjusting,
tighten the handle.
010132
E
Figure 3-3. Adjusting LED Fixture
Prestart Checklist
Before starting the unit, all items in the prestart checklist
must be completed. If any issues are identified, the user
must not use the unit until the issue is resolved.
(000100a)
WARNING
Consult Manual. Read and understand manual
completely before using product. Failure to
completely understand manual and product
could result in death or serious injury.
 Verify all maintenance procedures are up to date. For
more information, refer to General Maintenance and
Winch Use, Operation and Maintenance.
 Perform a walk-around inspection. Refer to Daily
Walk-Around Inspection.
 Verify unit is level.
 Verify unit is dry. Look for water inside or near the
unit; dry if needed.
 For grounding requirements, follow any local, state,
oil and gas or petrochemical plant grounding, MSHA,
OSHA, CSA, IEC, IEEE, NFPA, ABS Marine and
Maritime guidelines as applicable.
 Verify main breaker switch is in the OFF (O) position.
 Verify all circuit breakers are in the OFF (O) position.
 Inspect all electrical cords; repair or replace any that
are cut, worn, or bare.
 Verify all winch cables are in good condition and
centered on each pulley. Do not use if cables are
kinked or beginning to unravel.
 Verify all covers and guards are in place and properly
secured.
 If using 20 A shore power, verify convenience
receptacle is functional.