Operating Guide

10 Owner’s Manual for Chipper/Shredder
General Information and Setup
3. Fill tank with fresh, unleaded fuel with a minimum
85 octane rating to 1–1.5 in (25.4–38.1 mm) below
top of the fill neck to allow for fuel expansion.
NOTE: Do not ov
erfill.
4. Ins
tall fuel fill cap. Secure tightly.
Checking Tire Pressure
WARNING
Loss of control. Do not overinflate tires. Overinflation
could cause a blow out, which could result in loss of
control. Loss of control could result in death, serious
injury, property or equipment damage.
(000428)
1. See Figure 2-13. Remove valve stem protective
cap (A) and check tire pressure using a tire pres-
sure gauge.
A
010541
Figure 2-13. Valve Stem Protective Cap
2. V
erify tire pressure is in accordance with recom-
mended pressure stamped on side of tire. Add or
re
move air as needed.
NOTE: Do no
t over inflate tires.
3. Re
place valve stem protective cap.