Install Manual

6 Installation Manual for Generac PWRcell Inverter
General Information
Serial Number Location
Refer to Figure 2-1 to locate unit serial number (A).
Record the information from this tag in Table 1: Generac
PWRcell Inverter Important Information on the inside
front cover of this manual. When requesting assistance
you may be asked to provide this information.
A
009954
Figure 2-1. Serial Number Location
Unit Dimensions
1
B
A
C
009955
Figure 2-2. Unit Dimensions
A
B
C
About Generac PWRcell Inverters
The Generac PWRcell Inverter connects to the Generac
PV Link™ and Generac PWRcell Battery to form the
Generac PWRcell system for grid-interactive solar-plus-
storage.
Upon the loss of grid power, Generac PWRcell Inverters
disconnect from the grid and provide AC power to
support protected loads when configured to do so.
All Generac PWRcell products use the REbus™ 380
VDC nanogrid to connect energy sources, storage, and
loads. The REbus nanogrid automates the flow of power
to enable plug-and-play setup and operation of Generac
PWRcell equipment. For more information about REbus,
visit www.generac.com.
In Figure 2-3 Generac PWRcell Inverter (E) is directly
connected to Generac PV Link (B) and Generac PWRcell
Battery (C) on DC (REbus) line (D). To the right of the
inverter are AC lines: 120/240 VAC for grid and home
loads (G), and protected loads (H) support up to 50 A.
009893
A
B
C
D
E
F
G
H
.
Figure 2-3. Generac PWRcell System Example
A Solar Panels E Generac PWRcell Inverter
B Generac PV Link F Grid
C Generac PWRcell Battery G Loads
D REbus H Protected Loads
24.5 in (622 mm)
19.25 in (489 mm)
8 in (203 mm)