Product Manual

Operation

12 Homelink Upgradeable Manual Transfer Switch Owner’s Manual

Installation Summary

1. Verify installation has been properly performed as

outlined by the manufacturer and meets all applica-

ble laws and codes.

2. Verify proper operation of the system as outlined in

the appropriate installation and owner’s manuals.

3. Educate end user on proper operation,

maintenance and service call procedures.

Shutting Generator Down While

Under Load

(Automatic HSB Generator Only)

To turn the generator OFF during utility outages to

perform maintenance, or conserve fuel, follow these

important steps:

To turn the generator OFF (while running in AUTO and

Online):

1. Turn main utility disconnect OFF.

2. Turn main line circuit breaker (MLCB) on generator

to OFF (OPEN).

3. Allow generator to run and cool down for

approximately one minute.

4. Turn generator OFF.

NOTE: If turning the unit off longer than 24 hours,

remove F1 fuse from generator controller.

To turn the generator ON:

1. Install F1 fuse if necessary.

2. Put the generator back into AUTO and allow to

start and warm up for a few minutes.

3. Set MLCB on the generator to ON.

The system will now be operating in automatic mode.

The main utility disconnect can be turned ON (CLOSED).

NOTE: To shut the unit off, this complete process must

be repeated.

Figure 4-1. Homelink Features

A. Rocker Switch (Utility or Generator selector)

B. Utility Light (loads are on generator, but utility is available)

C. Generator Power Light (generator is on)

D. Circuit Breakers

E. Screws

This switch can be upgraded

for use with a Generac

home standby generator.