Battery - Safety Data Sheet
                                                                                                                                            Material Safety Data Sheet 
Report No.: TCT220425M002                                                                                                          Page 4 of 10 
Hotline: 400-6611-140      Tel: 86-755-27673339      Fax: 86-755-27673332      http://www.tct-lab.com 
Section 5- Fire Fighting Measures 
第五部分  消防措施 
Characteristics of 
Hazard 
危险特性
Dusts at sufficient concentrations can form explosive mixtures with air. Combustion 
generates toxic fumes. 
高密度粉尘遇空气会形成爆炸性混合物。燃烧生成有毒烟雾。 
Hazardous 
Combustion 
Products 
燃烧产生的危险物
品
Carbon dioxide. 
二氧化碳。 
Fire-extinguishing 
Methods and 
Extinguishing 
Media 
灭火方法及灭火剂
For small fires, use water spray, dry chemical, carbon dioxide or chemical foam.   
对于小型火险,可使用水枪,干冰(也就是液态二氧化碳)或化学泡沫。 
Attention in 
Fire-extinguishing 
灭火注意事项
Wear self-contained breathing apparatus in pressure-demand, MSHA/NIOSH 
(approved or equivalent) and full protective gear. 
因为压强关系,要穿戴可呼吸式全身防护装备,MSHA/NIOSH(经认证或等效的),
以及佩戴全套防护装置。 
Section 6- Accidental Release Measures 
第六部分  泄露应急处理 
Personal Precautions, protective 
equipment, and emergency procedures 
个人预防措施、防护装备和应急程序
In case of rupture. Attention! Corrosive material. 
Avoid contact with skin, eyes and clothing. Ensure 
adequate ventilation. Use personal protective 
equipment as required. Evacuate personnel to safe 
areas. Keep people away from and upwind of 
spill/leak. Refer to protective measures listed in 
Sections 7 and 8. 
万一破裂。注意!腐蚀性物质。避免接触皮肤,眼睛或
衣服。确保空气流通。根据需要使用个人防护装备。将
人员撤离到安全区域。让人们远离溢出/泄漏处和处于
逆风。参考第七部分和第八部分中列出的防护措施。 
Environmental Precautions 
环境保护措施
Prevent product from contaminating soil and from 
entering sewers or waterways. 
防止产品污染土壤和进入下水道或水道。 
Methods and materials for Containment 
方法和材料控制
Stop the leak if safe to do so. Contain the spilled 
liquid with dry sand or earth. Clean up spills 
immediately. 
出于安全,阻止泄漏,可以用干砂或泥土来遏制液体溢
出,立即清理溢出物。 
Methods and materials for cleaning up 
清理的方法和材料
Absorb spilled material with an inert absorbent (dry 
sand or earth). Scoop contaminated absorbent into 
an acceptable waste container. Collect all 
contaminated absorbent and dispose of according to 
directions in Section 13. Scrub the area with 
detergent and water; collect all contaminated wash 










