Installation Guide
Table Of Contents
- Installation Guidelines 60 Hz Air-Cooled Generators
- Table of Contents
 - Section 1: Safety Rules & General Information
 - Section 2: Unpacking and Inspection
 - Section 3: Site Selection and Preparation
 - Section 4: Generator Placement
 - Section 5: Fuel Conversion / Gas Connections
 - Section 6: Electrical Connections
 - Section 7: Control Panel Startup / Testing
 - Section 8: Troubleshooting
 - Section 9: Quick Reference Guide
 - Section 10: Accessories
 - Section 11: Diagrams
 
 

Control Panel Startup / Testing
38 Installation Guidelines for 60 Hz Air-Cooled Generators
Figure 7-4. Install Wizard Menu Map
Select Minute (0-59)
- 0 +
ENTER
ENTER ENTER ENTER
Select Year (0-99)
- 13 +
*
Select Month (1-12)
- 2 +
*
Select Date (1-31)
- 13 +
**
006668
ENTER
ENTER
ENTER
Controller assigns
random date and time
for biweekly exercise.
ENTER
Switched to OFF
Hours of Protection
0 (H)
SYSTEM
SETUP WIFI
DATE/TIME
SUB MENUS
ENTERESC
ENTER
Select “Yes” then Press “Enter” to continue or Press “ESCAPE” to escape out of updating.
During update process the Blue “Manual” light flashes, then the Green “Auto” light flashes. Sequence 
does this twice. When update is complete the unit returns to Install Wizard menu.
When the controller powers up the very first screen displays the version number for a few seconds.
When update is complete remove Thumb Drive, then follow the Install Wizard Menu.
* Re-try using a higher quality 
USB drive. File names on the USB 
cannot have more than 8 characters.
ENTER
USB Only–No WiFi
<Enter> to Begin
Install Wizard
Set Exercise...
Exercise Time
HH:MM Day Biweekly 
Current: V X.XX
USB: X.XX
Are You Sure?
- Yes or No +
Firmware Update
<- Insert USB ->
Possible Message(s):
Corrupted File
Invalid File
File Not Found
Unsupported Device*










