Cut Sheet

Table Of Contents

Model No. 0066130 Home Standby Remote Start Kit

Instruction Sheet 5

Figure 4. Bottom (underside) of Nexus Controller - Version #3

2.2 - Programming (for all Nexus versions) - Perform the following steps to enter the password and enable the two-wire

start:

1. Be certain that both battery leads are connected, the 7.5 Amp fuse is installed and the generator switch is in the OFF mode.

NOTE: Once the password has been entered and you go to the EDIT screen, the password will be canceled when you exit that

screen. It can be re-entered again, if necessary.

2. Press the ESCAPE key to display the menu screen.

3. Press the following key sequence: UP, UP, ESCAPE, DOWN, UP, ESCAPE, UP. This will enter the password.

4. Press ESCAPE until the menu is displayed. Use the up/down arrow keys to navigate to the EDIT field and then press ENTER to display the

EDIT menu.

5. Use the up/down arrow keys to scroll through the parameters until REMOTE START ENABLE is displayed. Press ENTER to select this

parameter as the one to be edited.

6. Use the up/down arrow keys to change the display to read YES.

7. Press ENTER to store the data. Remote start is now enabled.

8. Place the generator in the AUTO mode.

9. After completing installation, verify that the two wire start is functioning properly.

3. Evolution Controller (2013 and later)

1. Unlock and open the generator lid.

2. Turn the generator switch to the OFF mode.

3. Remove the 7.5 Amp fuse from the top of the control panel.

4. Remove the generator front panel.

5. Disconnect the negative (-) black lead from the generator battery.

NOTE: The exercise function will need to be reset every time the 12 volt battery and T1 power to the generator are disconnected and

then reconnected, and/or when the fuse is removed and T1 power is removed from the generator.

Version 3 – Controller part number 0H6680T

Bottom of Nexus

Control Panel

Harness End

of Connector

9-Pin

Connector