Product Manual A

LIGHT TOWER SET UP

1. For maximum light coverage locate tower at ground level or in a spot higher than the area being illuminated by

the lamps.

WARNING

The mast extends up to 25 ft (7.6 m). Make sure area above the trailer is open and

clear of overhead wires and obstructions.

2. Place the trailer on firm ground that is relatively flat. This will make it easier to level the tower. Block the wheels

on the trailer to keep it from moving (A).

3. Remove the locking pin on the tongue jack and rotate it 90º. Replace the locking pin (B). Turn the jack handle

clockwise to raise the trailer tongue off of the towing vehicle.

4. Connect a good earthen ground to the grounding stud on the frame of the trailer near the trailer tongue (C).

Note: Consult local codes for proper grounding requirements.

5. Pull the locking pin (D) on the outrigger and pull each outrigger out until the spring loaded locking pin snaps back

into place. Pull the locking pin on the outrigger jack and rotate each jack 90º so the jack pad is facing down and

the spring loaded pin snaps back into place.

6. Pull the locking pin on the rear jack (E) and rotate it 90º until the spring loaded pin snaps back into place. Turn

the jack handle clockwise to start leveling the trailer. Adjust all four jacks by turning their handles clockwise (F)

until they are firmly in contact with the ground and the trailer is as level as possible.

7. Before raising the mast it may be necessary to adjust the lamps. The lamps may be adjusted up, down, left or

right by loosening the wing nuts on the trunnion (G) and aiming the lamps in the desired direction. Tighten the

hardware completely and make sure the lamps are connected to the junction box (H).

DETAIL C

DETAIL D

DETAIL F

DETAIL G