Product Manual A

REMOVING THE LIGHTS FOR TRANSPORTATION

1. On units equipped with quick disconnect fittings for the lights, disconnect the power

cords from the junction box at the top of the mast. Replace the dust caps on the

junction box. On hard wired units, remove the junction box cover, located on the

top of the mast, and disconnect ONLY the mast light wires from the connectors.

To release the mast light wires from the connectors, flip the locking levers down

and pull out the appropriate wires.

2. Remove the lights by removing the wing nut that holds the light fixture bracket to

the cross tube.

TOWING THE TRAILER

Once the engine is shut down and the mast and lights are properly stowed, the trailer can be made ready for transport.

1. Raise the rear jack completely and release the locking pin to rotate it up into the travel position. Make sure the

locking pin snaps into place.

2. Raise the outrigger jacks completely and release the jack locking pin to swing the jacks up into the travel position.

Make sure the locking pins snap into place. Release the outrigger locking pins and slide the outriggers into the

trailer frame until the locking pins snap into place.

3. Use the tongue jack to raise or lower the trailer onto the hitch of the towing vehicle. Lock the hitch coupling and

attach the safety chains or cables to the vehicle. Remove the jack locking pin and rotate the jack into the travel

position. Replace the locking pin.

4. To ensure proper operation of the jacks, lube the grease fittings located on the leveling jacks. Refer to “Jack

Maintenance” on page 25. For maintenance interval information, refer to the charts on pages 23 & 24.

5. Connect any trailer wiring to the tow vehicle. Check for proper operation of the stop and signal lights.

6. Make sure the doors are properly latched.

7. If the trailer is going to be driven over rough ground, remove the bulbs from the light fixtures.

8. Check for proper inflation of the trailer tires. Refer to Specifications on page 9 for the appropriate tire pressure.

9. Maximum recommended speed for highway towing is 45 mph (72 km/h). Recommended off-road towing speed

is not to exceed 10 mph (16 km/h) or less, depending on the terrain.