Product Manual A

RAISING THE MAST

1. Set up and level the trailer as described in “Light Tower

Set Up” on page 13.

WARNING

The trailer must be leveled with

the outriggers extended before

raising the mast. The

outriggers must remain

extended while the mast is up.

Failure to level the trailer or

extend the outriggers will

severely reduce the stability of

the unit and could allow the

tower to tip and fall.

2. Check the mast cables for excessive wear or damage.

Make sure the cables are properly centered in each

pulley (A). Check the electrical cord for damage.

WARNING

Do not start the unit if the

insulation on the electrical

cord is cut or worn through.

Bare wires in contact with the

mast or frame may energize the

trailer and cause electrocution.

Repair or replace cord.

3. Press and hold the winch control toggle switch (B)

upward to telescope the mast to the desired height.

Extend the mast cautiously, making sure that the coiled

electrical cord is extending at the top sections of the

mast. If, for any reason, the winch cables begin to

develop slack or any of the mast sections get stuck,

STOP IMMEDIATELY and contact an authorized ser-

vice center.

CAUTION

Do not extend the mast beyond

the colored mark on top of the

lower mast section (C). A limit

switch on the main mast section

will disconnect power to prevent

over-extending the mast.

4. The mast can be rotated by loosening the locking knob at the bottom of the mast (D). Turn the mast until the

lights face in the desired direction and then tighten the knob.

WARNING

Never raise or lower the mast while the unit is operating.

STOP

DETAIL C

DETAIL B