Product Manual

Owner’s Manual for Dry-Prime Diesel Trash Pumps 27
Operation
Figure 3-30. PIN Change - Awaiting Confirmation
If the new PINs match, a confirmation screen is
displayed.
Figure 3-31. PIN Change -Confirmed
If the two PINs do not match, an error message is
displayed and the PIN is unchanged.
Figure 3-32. PIN Change - PIN Incorrect
IMPORTANT NOTE: If the PIN is changed from the
default and the new PIN is lost, the configuration mode
will not be accessible. Clearing the PIN requires returning
the display to LOFA Industries Inc. for service. Contact
LOFA Industries Inc. at 770-569-9828.
About
Displays the following product information:
Figure 3-33. About Menu
NOTE: This screen can not be exited until the checksum
calculation is complete. Checksum calculation takes
approximately 10 seconds and is complete when the
checksum value changes from “Calculating”… to a
hexadecimal value such as 0x704E – OK.
Autostart Menu
This submenu allows the user to configure automatic start/
stop operation. Refer to Automatic START and STOP for
more information.
Figure 3-34. Autostart Menu
Mode
This menu selects the basic automatic start and stop
operation mode. Button 4 cycles between Single Switch,
Dual Switch, Transducer, and Transducer & Switch.
Function
This menu selects the automatic start and stop function.
Button 4 cycles between Empty, Fill, Maintain Out and
Maintain In.
Throttling Menu
The throttling menu allows the user to configure throttle
control. It also allows programming of the automatic start and
stop throttle profiles as shown in Figure 3-2 .
JOB N/A
CONFIG Generac programmed controller part
number
ADAPTER Last adapter serial number used to
program the controller
VERS Software version number
PRODUCT Controller model name
RUN TIME Hours the unit has been run