Product Manual

24 Owner’s Manual for Dry-Prime Diesel Trash Pumps
Operation
Figure 3-17. Gauges Menu
Max RPM
Sets the full scale RPM indicated by the tachometer gauge.
RPM 2500, 3000, 3500, 4000, 4500, 5000, 6000, 7000,
8000, or 9000
Max Speed
Sets the full scale speed indicated by the speedometer
gauge.
Quad Adjust
Allows the user to disable Adjust mode of the Analog and
Digital Gauge Pages. Button 3 disables while button
4 enables Quad Adjust. Disabling Adjust mode locks
the current gauge configuration and prevents the
operator from accidentally changing the gauge
configuration.
Voltmeter
Leave setting at the 12V factory default. (24V is not
available on this unit.)
Service Timers
Sets the 16 service timers used to alert operator of
needed maintenance and resets the service timer.
Setting the service interval to 0 disables the timer and the
word Off is displayed.
Pressing button 4 allows adjusting the selected service
timer.
Button 1 decreases the service interval time while
button 2 increases the service interval time in 10 hour
increments. Holding button 3 for approximately three
seconds resets Next Service In to the current service
interval. The service timer descriptions can be changed
using the CANplus Configurator.
The message is displayed on each power up until the
elapsed timer is disabled or reset.
NOTE: It is not possible to set the service timers if
engine hours are not being received by the display
.
Figure 3-18. Service Timers Menu
System Menu
The System menu allows the user to configure items
affecting how the system functions. Button 4 cycles
through the available values for the selected item.
.
Figure 3-19. System Menu
Demo
The display supports several demo modes to operate with
simulated data. Mode 1 simulates speed data and engine
parameters. Mode 2 only simulates engine parameters.
Mode 3 simulates speed data, engine parameters, and
alarms. Mode 0 disables Demo mode. Demo is automati-
cally set to 0 (Off) if live data is received.
Restore Defaults
This allows resetting of all configuration information to
default US or Metric units. Additionally, the display
is reset to the initial configuration.
.
Figure 3-20. Restore Defaults Menu
MPH 15, 20, 25, 30, 35, 40, 45, 50, 55, 60, 70, 75,
80, 85, 95, or 100
km/h 20, 30, 40, 50, 60, 70, 80, 90, 100, 110, 120,
130, 140, 150, or 160
HOLD
RESET
US Met