Product Manual

Owner’s Manual for Dry-Prime Diesel Trash Pumps 13
General Information
Trailer Tongue Preparation for Use
If the unit is shipped with the trailer tongue in the upright
position, follow the steps below to lower the tongue.
1. See Figure 2-7. Move the front jack from the
tongue to the location shown and lower the jack.
2. Lower the rear jacks to prevent the unit from
tipping backwards during procedure.
Figure 2-7. Install Tongue Jack
3. See Figure 2-8. Loosen but do not remove the
nylon lock nuts on bolts A and B.
4. Remove the lower bolt and nylon lock nut securing
the tongue braces to the tongue (C).
Figure 2-8. Remove Lower Bolt
5. See Figure 2-9. Move the right tongue brace (D)
upward to allow access and then remove the rear
bolts and nylon lock nuts (E) as shown.
Figure 2-9. Remove Rear Bolts
6. See Figure 2-10. Remove the upper bolt, nut, and
washers (F) to allow the tongue to pivot.
Figure 2-10. Remove Upper Bolt, Nut, and Washer
7. See Figure 2-11. Lower the trailer tongue and
install bolts (E) removed in step 4 with new nylon
lock nuts. Do not tighten until bolt (G) is installed
and tightened.
Figure 2-11. Lower Tongue
8. See Figure 2-12. Align the lower holes on the
tongue braces with the slot in the tongue. Install
the bolt with a new nylon lock nut (G). Tighten to
80-109 ft-lbs (108-148 Nm).
9. Tighten bolt (E) to 80-109 ft-lbs (108-148 Nm).
10. Install the upper bolt, nut, and washers (F) in the
hole near the top of the tongue mounting bracket.
The bolt should be snug against the bracket.
11. Tighten the nylon lock nuts on bolts A and B to 80-
109 ft-lbs (108-148 Nm).
Figure 2-12. Install Fasteners
002314
002315
A
C
A
B
002342
D
E
E
002343
F
002344
002317
E
E
G
G
F
F
A
A
B