Product Manual A

Operation
48 MTP4000-6000DZV/DZD Operating Manual 31609 A
LIFTING THE UNIT
Remove suction and discharge piping from pump prior to
moving. Make sure the equipment being used to lift the unit
is in good condition and has sufficient capacity.
Note: Refer to “Specifications” on page 7 for approximate
weights.
Always remain aware of the position of other people and
objects around you as you move the unit.
A central lift point is located on the top of the unit. Attach
any slings, chains or hooks directly to the lift point. Use the
forklift pockets with care. Approach the unit as perpendic-
ular as possible to avoid any damage to the unit. Make
sure any obstructions are clear of the forklift tines before
lifting.
Figure 19 - Lifting Points
WARNING
Use lifting and moving equipment that is in good condition and that has adequate
capacity to prevent personal injury or equipment damage. When lifting the pump end
with chains or cables, position them so the load is balanced and so pump damage
will not occur. Suction and discharge hoses and piping must be removed from the
pump before lifting.
Central
Lift Point
Forklift
Pockets
01273