Product Manual A

General Information
31609 A MTP4000-6000DZV/DZD Operating Manual 29
The digits of the PIN are entered by using the buttons corresponding to the digits of
the PIN.
Button 1 adjusts the first digit of the PIN. Button 2 adjusts the second digit,
button 3 the third digit and button 4 the fourth digit. The PIN is entered
using button 5 .
PIN Change
WARNING
If the PIN is changed from the default and the new PIN is lost, the configuration mode
will not be accessible. Clearing the PIN requires returning the display to LOFA
Industries Inc. for service. Contact LOFA Industries Inc. at 770-569-9828.
About
Displays the following product information:
JOB N/A
CONFIG Generac programmed controller part number
ADAPTER Last adapter serial number used to program the controller
VERS Software version number
PRODUCT Controller model name
RUN TIME Hours the unit has been run
00365
This allows changing the PIN.
The user is prompted
for the current PIN.
The user is prompted
for the new PIN.
The new PIN must be confirmed
before the PIN is changed.
If the new PINs match, a
confirmation screen is
displayed.
If the two PINs do not match,
an error message is displayed
and the PIN is unchanged.
00366
JOB:
CONFIG:
ADAPTER:
VERS:
PRODUCT:
RUN TIME:
49943A
2575
3.02
CP600
00367