Product Manual A

General Information
10 MTP4000-6000DZV/DZD Operating Manual 31609 A
3. Remove the shipping brace and slide it into the trailer tube opening. Secure the brace to the trailer with the
bolt located on the underside of the trailer and a new nylon locking nut. Refer to #2 in Figure 3.
4. Flip the trailer tongue down and reinstall the bolts and washers removed in step 2 using two new nylon lock-
ing nuts. DO NOT reuse nylon locking nuts. Tighten the bolts to 80-109 ft-lbs (108-148 Nm).
Figure 4 - Reinstall Hardware
Note: If the jack was used to support the unit while removing the shipping brace, the jack must be moved back to
the tongue location before the unit can be towed.
1. Connect the trailer tongue to a vehicle or other support and move the jack to the tongue location.
2. Tighten the bolt inside the jack mounting tube nearest the frame.
01266