Dimensions Guide

5 of 5
Generac Power Systems, Inc. • S45 W29290 HWY. 59, Waukesha, WI 53189 • generac.com
©2013 Generac Power Systems, Inc. All rights reserved. All specifications are subject to change without notice. Bulletin 0198010SBY-E Printed in U.S.A. 03/13/13
731.9 mm
[28.8 in.]
637.6 mm
[25.1 in.]
LEFT SIDE VIEW
642 mm
[25.3 in.]
76.2 mm [3.0 in.]
PEA GRAVEL
MINIMUM
TRANSFER
SWITCH
8KW - 17KW
(IF SUPPLIED)
TRANSFER
SWITCH
20KW
(IF SUPPLIED)
1218 mm
[47.9 in.]
FRONT VIEW
1226 mm
[48.3 in.]
H2
H1
W1
W2
H2
H1
W1
W2
Dimensions shown are approximate. Contact your Generac dealer for certified drawings. DO NOT USE THESE DIMENSIONS FOR INSTALLATION PURPOSES.
Model # Product Description
5819 26R Wet Cell Battery
Every standby generator requires a battery to start the system. Generac offers the
recommended 26R wet cell battery for use with all air-cooled standby product.
6212 Cold Weather Kit
If the temperature regularly falls below 32°F (0°C), install a cold weather kit to maintain
optimal battery and oil temperatures. Kit consists of a battery warmer and oil filter heater with
built-in thermostats.
5621
Auxiliary Transfer Switch
Contact Kit
The auxiliary transfer switch contact kit allows the transfer switch to lock out a single large
electrical load you may not need. Not compatible with 50 amp pre-wired switches.
5666 Fascia Base Wrap Kit
The fascia base wrap snaps together around the bottom of the new air cooled generators.
This offers a sleek, contoured appearance as well as offering protection from rodents and
insects by covering the lifting holes located in the base.
5704 Paint Kit
If the generator enclosure is scratched or damaged, it is important to touch-up the paint to
protect from future corrosion. The paint kit includes the necessary paint to properly maintain
or touch-up a generator enclosure.
6482 - 8kW
6483 - 11kW
6484 - 13kW
Scheduled Maintenance Kit
Generac's scheduled maintenance kits provide all the hardware necessary to perform
complete routine maintenance on a Generac automatic standby generator.
5928 Wireless Remote
Completely wireless and battery powered, Generac's wireless remote monitor provides you
with instant status information without ever leaving the house. Not compatible with Centurion
ES systems.
5951 Advanced Wireless Remote
Remotely control generator functions with the advanced model's LCD display. In addition to
remote testing of the generator, set the exercise cycle and maintenance interval reminders.
Not compatible with Centurion ES systems.
6199 PMM Starter Kit
The PMM Starter Kit consists of a 24V, field installed transformer that enables the use of
the 24V Power Management Modules (PMMs). This kit includes one PMM. The standard
controller (without starter kit) can control two HVAC loads with no additional hardware.
6186
Power Management Module
(50 Amps)
Power Management Modules are used in conjunction with the Smart Switch to increase its
power management capabilities. It gives the Smart Switch additional power management
flexibility not found in any other transfer switch. Not compatible with pre-wired switches.
6463 Mobile Link™ Device
The Mobile Link device allows you to check the status of your generator from anywhere that
you have access to an Internet connection from a PC or with any smart device. You will even
be notified when a change in the generator’s status occurs via e-mail or text message.
8/11/13kW available accessories
dimensions
8/11/13kW