Installation Guide

Generator Placement

18 Installation Guidelines for Air-Cooled Generators

4.2 — Fascia Installation (If Applicable)

• Locate the four (4) threaded black rubber bumpers located in the Owner’s manual bag.

• Remove the four (4) bumpers from the bag and screw them into threaded holes located inside the end pieces of

the fascia (two each) opposite one another (A).

• Once the bumpers are installed, snap one of the end pieces into one of the front / rear pieces of fascia. Repeat

this action with the other two remaining pieces of fascia.

NOTE: Do not assemble all four pieces together at this point (B).

• Place both assemblies at the base of the generator and fit the rubber bumpers into the lifting holes in the gener-

ator base (C).

• Once aligned, snap together the two remaining connection points.

Figure 4-3. Fascia Installation