Manual

Generac Portable Produc_s2100 PSIPressureWasher

Add Engine Oil and Fuel

• Place pressure washer on a level surface.

CAUTION

Before connecting garden hose to wa:er inlet, fnspect

inlet screen (Ffgure 6), Cle_n screen ff i: cont_fns

debrTsor have Tt replaced if damaged. Refer to the

sectTon "O-Ring MaTetenance" Tfinlet screen Ts

damagud, DO NOT RUN PRESSLJREWASHER IF

INLET SCREEN IS DAMAGED.

• Refer to engTneowner's manual and follow oil and fuel

recommendatTons and instructTons,

NOTE: Check oTIoften durTng engTnebre_k4n, Refer to

engine owner's manual for recommendations,

Connect Hose and Water Supply to

Pump

IMPORTANT: To avoid pump damage, you must _ssemble

_he nozzle extension to the spray gun and attach all hoses

before you s_r% the engine,

I, Uncoil high pressure hose and att._ch one end of hose

to base of spray gun (Figure 4),Tighten by hand,

NOTE: Remove and discard all pump shipping caps before

at_ching hoses,

2, Attach other end of high pressure hose to high

pressure outlet on pump (Figure 5),Tighten by hand,

_t, Run wa_er _hrough your garden hose for 30 seconds

to clean out any debris,

IMPORTANT: DO NOT siphon standing wa_er for the

wa_er supply, Use ONLY cold water (less than 100:F),

S, Connect _he garden hose (not to exceed S0 feet in

length) to the water inlet_Tighten by hand (Figure 6),

CAUTION

6, Turn ON the wa_er and squeeze the trigger on the

gun to purge the pump system of air and impurities,