Manual

Generac Portable Products 2100 PSI PressureWasher

PREPARING THE UNIT

FOR STORAGE

Water should not remafn in the unft for long perfods of

time, Sedfments or minerals can deposit on pump parts and

==freeze" pump action. If you do not plan to use the

pressure washer for more than 30 days,follow this

procedure:

I. Flush chemical fniectfon hose by placing filter fnto a pall

of clean water whfle running pressure washer fn low

pressure mode (adiustable nozzle fn forward positron),

Flush for one to two mfnutes,

2. Shut off engine and let ft cool, then remove high

pressure and garden hoses, Disconnect spark plug wire

from spark plug,

3. Empty/pump of all pumped liquids by pullfng recoil

handle about 6 times,Thfs should remove most liquid

in pump,

4, Use PumpS_ver to prevent corrosion bufld up and

freezfng of pump.

5. Store unft in a clean, dry area.

Protectin 8 the Pump

To pro_ect the pump from damage caused by mfneral

deposfts or freezing, use PumpSwer to treat pump, Thfs

prevents freeze damage and lubricates pfstons and seals.

NOTE: PumpSaver is available as an optfonal accessory, It

is not included with the pressure washer. Conts_ tile

nearest audlorfzed service center to purchase PumpSwer,

CAUTION

! A!w_ wear c_e protectionwhen usingPurnpS_cer.

To use PumpSayer, make sure the pressure washer is

turned off and disconnected from supply water. Read and

follow all instructfons and warnings given on the PumpSaver

container.

NOTE: PumpSaver will drip from pump after treatment

and wfll s_in wood and concrete,

NOTE: If PumpS_ver fs not avaflable, draw RV antffreeze

(non-alcohol) into the pump by pouring the solutfon fnto a

3-foot sectfon of garden hose connected to fnlet adapter

and pullfng recoil handle wcfce,

STORING THE ENGINE

Seethe engineowner's manual for instructions on how to

properlyprepare the engine for storage,