Manual

GeneracPortableProducts2100PSIPressureWasher
Applying Detergent with the
Adiustable Nozzle
IMPORTANT: Use soaps designed specifically for
pressure washers. Household detergents could damage
the pump.
CAUTION
To apply detergent, follow these steps:
I, Revfewuseof adjus=ble nozzles,
2,
3,
Prepare detergent solution as required by iob.
Place filter end of chemical injection hose into
detergent confiner.
CAUTION
4. Slfde adiustable nozzle forward to low pressure mode.
Detergent cannot be applied with nozzle in hfgh
pressure posi_iom
5. Make sure g_rden hose is connected to water fnlet.
Check that high pressure hose fs connected to spray
gum and pump. Start engfne.
6. Apply detergent to a dry su_ace, starting at lower
portion of area to be washed and work upward, using
long, even, overlapping strokes.
7. Allow detergent to "soak fn" for 3-5 mfnutes before
washing and rinsfng. Re_pply as needed to prevent
surface from dryfng, DO NOT allow detergent to dry
on (prevents streaking),
IMPORTANT: You must flush the chemf_l fniec_ion
system after each use by placing the filter fnto a bucket of
clean water, then rum the pressure washer fn low pressure
for I-2 minutes.
Pressure Washer Rinsing
For Rinsing=
I. Slide the nozzle backward to high pressure, press the
trigger and wait for the detergent to clear,
NOTE:You c_n also stop detergent from flowfng by simply
removfng chemfcal injection hose from bottle.
2. Keep the spray gun a safe dis_nce from the area you
plan to spray.
3. Apply a high pressure spray to a small are_, then check
the surface for damzge. If no damzge is found, it is okay
to contfnue cleanfng.
,Keep Spraynozzle between8 to 2,4inches &wayfrom Cleaning
surf'aC_
, Be extremely _reful ({ FoumUSt Use_e pr_SSU_washer {rein
ladder. Scaffoid(ngOr a_ Other relatJveiyunscabieiocadeni
' Firmly grasp SP_ gun v_thboth hands w_en us!ng high
4. Start at the top of the area to be rinsed, working
down wfth same overlappfng strokes as you used for
washfng and applyfng detergent.
Automatic Cool Down System
('l-hernnal Relief)
If you rum the engine on your pressure washer for
3-5 minu_es without pressing the trigger on the spray gun,
circulating wa_er in the pump c_n re_ch temperatures
above 125°EThe system engzges to cool the pump by
discharging the warm water onto the ground.
mm_m
10