Owner's manual

• Placethe small filter end of the detergent siphoning tube
into the detergent container.
CAUTION! Keep the chemical injection tube from
coming in contact with the hot muffler.
• Make sure the black nozzle is installed.
NOTE: Detergent cannot be applied with the high
pressure nozzles (White, Green, Yellow, or Red).
• Make sure the garden hose is connected to the water
inlet.Check that the high pressure hose is connected to
the spraygun and the pump and start the engine.
• Apply the detergent to a dry surface, starting at lower
portion of area to be washed and work upward, using
long,even, overlapping strokes.
• Allow the detergent to soak in between 3-5 minutes
before washing and rinsing. Reapplyas needed to prevent
surface from drying. Do Not allow the detergent to dry
on (prevents streaking).
IMPORTANT: You must flush the chemical injection
system after each use by placing the filter into a bucket of
clean water, then run the pressure washer in low pressure
for I-2 minutes.
Pressure Washer Rinsing
A ARNING! Be extremely careful if you must
usethe pressure washer from a ladder, scaffolding
or any other relatively unstable location.Hose
water pressure builds as you climb. When you press
the trigger, the recoil from the initialspray can be
very strong. The high pressure spray could cause
you to fall ifyou are too close to the cleaning
surface.
Wash and Rinse Surface
This pressure washer permits regulation of output water
pressure by varying the engine speed and by turning the
pressure control knob on the pump. The Pressure
Command TM lever found on the front of the engine may be
set, as shown in Figure 19:
Pressure Low to High
Duty Light Medium Heavy
Application Auto Concrete Paint removal
Boat Driveway Degreasing
Furniture Deck
• Increaseor decrease spray pressure by turning the
pressure control knob counterclockwise or clockwise
respectively (Figure 20).
After you have applied detergent, scour the surface
and rinse it clean as follows:
• Apply safety latch to spray gun.
• Remove the black chemical nozzle from the nozzle
extension.
• Select and installthe desired high pressure nozzle
following the instructions"How to Use the Nozzles" on
page 10.
• Keepthe spray gun a safedistance from the area you
plan to spray.
• Adjust Pressure Command TM lever and pressure control
knob to obtain desired water pressure.
• Apply a high pressure spray to a small area and then
check the surface for damage.If no damage isfound, you
can assume it isokay to continue rinsing.
• Start at the top of the area to be rinsed, working down
with same overlapping strokes as you usedfor cleaning.
Automatic Cool Down System
(Thermal Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressingthe trigger on the spray gun,
circulating water in the pump can reach a temperature
between 125°-155°E At this temperature, the system
engagesand cools the pump by discharging the warm
water onto the ground. This system prevents internal
damage to the pump.
/
II