Manual

Y_&_ $_ra_on'

_ powE_e_ODUCT_

* Phce the hande onto the hande supports aHready

connected to the main unit. Make sure the holes in the

hande aHign with the holies on the hande supports

(Figure 2).

NOTE: It may be necessary to move the handHe supports

from side to side in order to aHign the hande so it will sHide

over the handHe supports.

° Insert the carriage boHt through the holies from the

outside of the unit and attach a phstic knob from the

inside of the unit.Tighten by hand (Figure 3).

, insert the "J" hook into the second from the left slot in

the accessory tray (Figure 4).

* Pinch the chemical hose that comes out of a hole in the

unit's base and slide it into the metal clip_ as shown in

Figure 5.

* Tilt the unit up by the handle and attach the metal clip to

the rib on the left underside of the accessory tray

(Figure 6). Slide the chemical hose through the metal clip

so that it is tight but not kinked.

Add Engine Oil

JNPORTANT: Any attempt to crank or start the engine

before it has been properly serviced with the

recommended oil may result in an engine failure.

* Place pressure washer on a [eve[ surface.

° Refer to the engine owners manual to add recommended

oil to engine.

NOTE: Check oil often during engine break-in. Refer to

engine owner's manual for recommendations.

Add Gasoline

WARNING! Never fill fuel tank indoors. Never

fi[[ fuel tank when engine is running or hot. Do Not

smoke when filling fuel tank.

WARNING! Never fill fuel tank completely full.

Provide space for fuel expansion.Wipe away any fuel

spillage from engine and equipment before starting.