Manual

bye& S_on _
_ _OV/ERp_r>_JCrs
H. Detach spray gun and nozzHe extension from hgh
pressure hose. Detach nozzHe extension from spray gun
and remove o:fing and screen from nozzHe extension.
Hush the screen_ spray gun_ and adiustabHe nozzHe
extension with dean water to dear debris.
2. If the screen is damaged_ the o:fing Halt contains a
repHacement inoHine fiker screen and an o:fing. [f
undamaged_ reuse screen.
3. PHace the inoHine fJker screen into the threaded end of
the nozzHe extension. Direction does not matter. Push
the screen in with the eraser end of a penciH untiH it
rests ilat at the bottom of the opening.Take care to
not bend the screen.
4. PHace the o°ring into the recess. Push the o°ring snugHy
against the inoHine fiker screen.
5. AssembHe the nozzHe extension to the spray gun, as
described earHier in this manual
Purge Pump of Air and
To remove air from the Dump, follow these steps:
Set up the pressure washer as described in "Preparing
Pressure VVasher For Use". Connect the water suppHy and
turn water on.
o PuHHthe trigger on the spray gun and hoHd.
o When the water suppHy is steady and constant_ engage
the safety Hatch.
To remove contaminants from the pump, follow
these stepst
o Set up the pressure washer as described in "Preparing
PressureWasher For Use". Connect the water suppHy
and turn water on.
o Start the engine according to instructionsin"To Start
Your Pressure VVasher".
° Remove nozzle extension from spray gun.
o Squeeze the trigger on the spray gun and hoHd.
o When the water suppHy is steady and constant, engage
the safety Hatch and attach the nozzHe extension.
Nozzle Maintenance
A puHsing sensation fek whiHe squeezing the spray gun
trigger may be caused by excessive pump pressure.The
principa[ cause of excessive pump pressure is a nozzHe
c[ogged or restricted with foreign materiak such as dirt,
etc.To correct the problem, immediately clean the nozzle
using the tooHs incHuded with your pressure washer and
foHHow these instructions:
I. Shut off the engine and turn off the water supply.
2. Detach the nozzHe extension from the spray gun.Twist
the nozzHe c[ockwise to the stream position. Using the
suppHied 2ram (5/64) aHHen wrench, remove the nozzHe
from the end of the nozzHe extension (Figure 21).
3. Remove the inoline filter from the other end of the
nozzHe extension.
4. Use the wire incHuded in the kit (or a smaHHpaper chip)
to free any foreign materia[ dogging or restricting the
nozzHe (Figure 2H).
5. Using a garden hose, remove additionaH debris by bacH<
flushing water through the nozzHe extension
(Figure 22). BacH<flush between 30 to 60 seconds.Turn
the adiustabHe nozzHe extension to stream spray and
move the nozzHe from How to high whiHe flushing.
6. Reinstall the nozzle and in4ine filter into the nozzle
extension. Do Not overtighten the nozzle with the
allen wrench.
7. Reconnect the nozzle extension to the spray gun.
8. Reconnect the water supply, turn on the water, and
start the engine.
13