Manual

Generac Portable Products 3000 PSIPressureWasher
• Ifthe choke lever has been moved to the "Closed"
position to start the engine, gradually move it to the
"Open" position as the enginewarms up.
• Attach the nozzle extension to the spray gun. Tighten by
hand (Figure I I).
• Select the desired quick connect nozzle and insertit into
the end of the nozzle extension (see "How To Use the
Nozzles").
• Disengagethe safety latch on the spraygun.
How to Stop Your Pressure Washer
• Move the throttle lever to the "Slow" position.
• Move the fuel valve to the "Off" position.
• Wait for the engine to idledown.
• Move the engine switch to the "Off" position.
• Simply shutting off the engine will not release pressure in
the system. Squeeze trigger on the spray gun to
relieve pressure in the hose.
Flow to Use the Nozzles
_ CAUTION! Never exchange nozzles without
lockingthe safety latchon the trigger.
The quick-connect on the nozzle extension allows you to
switch between five different nozzles. The nozzles varythe
spray pattern as shown below (Figure 12).
Follow these instructions to change nozzles:
• Engagethe safety latch on the spray gun.
•Putl back the collar on the quick-connect and pult the
current nozzle off. Store the nozzle in the space provided
on the handles storage panel.
NOTE: For a more gentle rinse, select the white 40° or
green 25° nozzle. To scour the surface, select the yellow
15° or red 0° nozzle. To applychemical, select the black
nozzle.
•Putl back on the collar, insertthe new nozzle and release
the collar. Tug on the nozzle to make sure it is securely
in place.
• For most effective cleaning,keep the spray nozzle
between B to 24 inchesawayfrom the cleaningsurface. If
you get the spray nozzle too close, you maydamage the
cleaning surface.
Low Pressure
apply
chemical
Black
25 °
High Pressure
White Green Yellow Red
40° 25° 15° 0°
/
9