Manual

ManualsBrandsGenerac ManualsPressure WasherOfficial Generac pressure washer

GeneracPortableProducts3000PSIPressureWasher

• Securehandleto thepressurewasherusingthefour

providedflangenuts.

• Slowlytipthepressurewasherbackinplaceandinsert

themulti-colorednozzlesinthespacesprovidedinthe

handle.

Install Oil Dipstick on Pump

CAUTION! You MUST remove the pump's shipping cap

and installthe oil dipstick. Failure to do so will void the

warranty and damagethe pump.

To install the oil dipstick:

• Make sure your unit is on a level surface.

• Remove and discard the shipping cap located on the

pump (Figure 2).

Pump Oil

Dipstick

• Install the oil dipstick.

Add Engine Oil

IMPORTANT: Any attempt to crankor start the engine

before it has been properly serviced with the

recommended oil may result in an engine failure.

• Place pressure washer on a level surface.

• Refer to the engine owners manual to add recommended

oil to engine.

NOTE: Check oil often during engine break-in. Refer to

engine owner's manual for recommendations.

Add Gasoline

_IL WARNING! Never fill fuel tank indoors. Never

fill fuel tank when engine is running or hot. Do Not

smoke when filling fuel tank.

_IL ARNING! Never fill fuel tank completely full.

Provide spacefor fuel expansion. Wipe awayany

fuel spillage from engine and equipment before

starting.

• Use clean regular unleadedfuel and store inapproved

clean covered containers. Use clean fill funnels. Never

use "stale" gasoline left over from last season or gasoline

stored for long periods.

• Clean the area around the fuel fill cap, remove the cap.

Slowly filltank to the bottom of the filler neck (Figure 3).

__ Maximum Fuel Level

Install the fuel cap and wipe up any spilled gasoline.

Connect Hose and Water Supply to

Pump

IMPORTANT: You must attach all hoses before you start

the engine. Starting engine without all hoses connected and

water supplied willdamagethe pump.

• Uncoil high pressure hose and attach quick connect end

of hose to the baseof the spraygun (Figure 4). Pull

down on the collar of the quick connect, slide onto the

spray gun and let go of collar. Tugon hoseto be sure of

a tight connection.