Manual

GeneracPortableProducts2,500PSIHighPressureWasher

NOTE: Check oil often during engine break-in. Refer to

engine owner's manualfor recommendations.

==m=q IM =ml Ee_ra

Add Gasoline

_ WARNING! Never fill fuel tank indoors. Never

fill fuel tank when engine is running or hot. Do Not

smoke when filling fuel tank.

_ WARNING! Never fill fuel tank completely full.

Provide spacefor fuel expansion.Wipe awayanyfuel

spillagefrom engine and equipment before starting.

• Use fresh, clean unleadedautomotive gasolineand store in

approved, clean, covered containers. Use clean fill

funnels. Never use "stale" gasoline leftover from last

season or gasoline stored for longperiods.

• Clean area around fuel fill cap, remove cap.

• Slowly add gasoline to fuel tank. Use a funnel to prevent

spillage. Fill tank to "Maximum Fuel Level" (Figure 8).

Connect high

pressure hose

here.

Attach the other end of the high pressure hose to the

high pressure outlet on the pump (Figure 10). Pull down

on the collar of the quick connect, slide fitting into the

pump and let go of collar. Pull on hose to be sure of a

tight connection.

_ Maximum Fuel Level

Install fuel cap and wipe up any spilled gasoline.

Connect Hose and Water Supply to

Pump

IMPORTANT: You must assemblethe nozzle extension

and attach all hoses before you start the engine. Starting

engine without all hoses connected and water supplied will

damagethe pump.

• Uncoil high pressurehose and attach quick connect end of

hose to the baseof the spraygun (Figure 9). Pulldown on

the collar of the quick connect, slide onto the gun andlet

go of collar. Tugon hose to be sure of a tight connection.

• Before you connect your garden hose to the water inlet,

inspectthe inlet screen (Figure I I). Clean the screen if it

contains debris, replace it if it isdamaged.DO NOT

RUN THE PRESSUREWASHER IF THE SCREEN IS

DAMAGED. NEVER SIPHON INLET WATER.

• Run water through the garden hose for 30 seconds to

clean out any debris. Turn off water.

• Connect the garden hose to the water inlet. Tighten by

hand (Figure II).