Manual

Generac Portable Products 7,500 EXL Generator

Installing Tray and Battery

To obtain electric start, you must purchase and installa

12Volt DC battery (Series U1-109). The battery should

be serviced as necessaryand fully charged prior to

installation. Install the battery asfollows:

• Find the battery tray and fasteners shipped loose in the

carton. You should have one battery hold down bracket,

a black battery cable, a red battery cable, two 7" Jbolts,

two lock washers, two fiat washers and two hex nuts.

• Remove the four battery tray screws from cradle.

• Position the battery tray and installwith screws removed

above (Figure 3).

• Set battery onto tray.

• Retain battery to tray with hold down bracket, two

J bolts, two lock washers, two fiat washers and two hex

nuts (Figure 4). Tighten with 3/8" wrench.

• Connect one end of the red battery cable to the

outboard terminal of the engine start switch.

• Connect other end of the red battery cable from the

engine start switch to positive (+) terminal on the

battery (Figure 5).

RED wire

from battery

BLACK wire

from battery

• Connect the black battery cable to the negative (-)

terminal on the battery (Figure 5).

• Connect the other end of the black cableto the engine,

not the frame (Figure5).

_ AUTION! Be sure the black cableisconnected

to the engine and not the frame. Failure to connect

cable to the engine block will result in damageto the

wiring which isnot covered under warranty.

• Double check all connections to ensure they are in the

correct locations and secure.