Liquid-Cooled Instruction Sheet

Engine Shutdown Add-On Kit 8
4.
See Figure 18. Connect crimped ends of 36 in. (91
cm) wire (C) and black wire from E-stop harness (D)
to rocker switch terminals at customer access cover.
Verify there is enough insulation removed to properly
connect and disconnect wires.
Figure 18 - Crimped Rocker Switch Wires
5. Position rear enclosure panel close to rear of
generator. Wires connected to switch in rear panel
will be routed and wired to inside of generator control
panel.
6. See Figure 19. Route loose end of 36 in. (91 cm)
wire (C) along existing harness to left side of control
panel.
Figure 19 - Wire Routing
7. See Figure 20. Crimp an insulated barrel splice
connector (E—supplied) to stripped end of 36 in. (91
cm) wire (C). Crimp open end of barrel splice
connector to the stripped black wire on pin side of
Deutsch connector.
Figure 20 - Connect Switch Wire
8. Using four screws with nylon washers, fasten fascia
over control panel.
9. See Figure 21. Apply one supplied engine shutdown
decal next to rocker switch.
Figure 21 - Engine Shutdown Decal
10. Install rear panel.
NOTE: To simplify installation, first engage right side of
panel and then rotate left side in toward enclosure.
Alternately work left and right sides in until slots are
aligned with screw holes on both sides. Avoid pinching
loose switch wires between panel and enclosure. Install
six screws with nylon washers and tighten until snug.
NOTE: Proceed carefully when removing rear enclosure
panel. Gently remove panel, allowing just enough room
to disconnect wires from switch terminals in access
cover. Once wires are disconnected, rear panel may be
fully removed and set aside. Reconnect auxiliary switch
wires before replacing rear panel.
D
C
004896
C
D
004902
E
C
004903
ON
OFF
ENGINE
SHUTDOWN
004899