Air-Cooled Instruction Sheet

Engine Shutdown Add-On Kit 4
Switch Wiring Installation
Switch(es) must be connected to the wire leads added to
the J2 wiring harness connector. If two switches are
installed, the switches must be wired in series with each
other.
Single Switch Wiring
(rear panel)
1. Cut two lengths of 18 AWG wire at 18 in. (46 cm).
2. Strip 3/8 in. (10 mm) of insulation from ends of both
wires.
3. Crimp an insulated quick disconnect connector to
one end of each wire.
4. Route stripped ends of each wire under generator
controller
5. Using insulated barrel splice crimp connectors
(supplied), crimp stripped end of each length of wire
to open wire leads in J2 wiring harness connector.
6. Connect other ends of wires (with quick disconnect
connectors) to switch terminals at rear panel.
7. If controller was removed during installation, install
controller. Re-attach controller fascia and intake end
panel.
8. See Figure 8. Apply supplied engine shutdown decal
next to the switch.
Figure 8 - Engine Shutdown Decal
9. Connect negative battery cable.
10. Install 7.5 A fuse and configure install wizard.
Dual Switch Wiring
(rear panel and divider panel)
1. Cut one length of 18 AWG wire at 12 in. (30 cm), one
length of wire at 18 in. (46 cm), and one length of
wire at 19 in. (48 cm).
2. Strip 3/8 in. (10 mm) of insulation from each end of all
three wires.
3. Crimp an insulated quick disconnect connector
(supplied) to one end of the 12 in. (30 cm) and 18 in.
(46 cm) lengths of wire.
4. Crimp an insulated quick disconnect connector to
each end of the 19 in. (48 cm) length of wire.
5. Connect crimped ends of 18 in. (46 cm) and 19 in.
(48 cm) wires to switch terminals at rear panel
.
6. Route loose ends of 18 in. (46 cm) and 19 in. (48 cm)
wires under the generator controller.
7. Crimp an insulated barrel splice crimp connector
(supplied) to stripped end of 18 in. (46 cm) wire.
Connect to one of the J2 wiring harness connector
lead
s.
8. Crimp an insulated barrel splice crimp connector to
stripped end of
12 in. (30 cm) wire. Connect to the
other J2 wiring harness connector lead.
9. Connect 12 in. (30 cm) and 19 in. (48 cm) wires to
switch terminals at divider panel.
10. If controller was removed during installation, install
controller. Re-attach controller fascia and intake end
panel.
11. See Figure 8. Apply supplied engine shutdown
decals next to switches.
12. Connect negative battery cable.
13. Install 7.5 A fuse and configure install wizard.
ON
OFF
ENGINE
SHUTDOWN