Air-Cooled Instruction Sheet

Engine Shutdown Add-On Kit 3
Rear Panel Installation
1. See Figure 4. Measure 1.5 in. (3.81 cm) down from
top edge of rear panel and 3 in. (7.6 cm) from left
edge of rear panel. Mark an X at this location. This
will be the center point for the switch mounting hole.
Figure 4 - Prepare Rear Panel
2. Use a step drill to bore a 13/16 in.(20.5 mm) diameter
hole in the rear panel.
IMPORTANT NOTE: Do NOT drill hole larger than 13/16
in. (20.5 mm)! An oversize hole will prevent switch
installation and cannot be repaired in the field. The
rear panel must be replaced
.
3. See Figure 5. Insert switch (supplied) into hole and
apply a small amount of silicone sealant around
perimeter for added weather resistance.
Figure 5 - Switch Installed on Rear Panel
Divider Panel Installation
1. See Figure 6. Measure 2 in. (5.1 cm) down from
underside of flange at top of divider panel. Measure 5
in. (12.7 cm) inward from front face of divider panel.
Mark an X at this location. This will be the center
point for the switch mounting hole.
Figure 6 - Prepare Divider Panel
2. Use a step drill to bore a 13/16 in. (20.5 mm)
diameter hole in the divider panel.
IMPORTANT NOTE: Do NOT drill hole larger than 13/16
in. (20.5 mm)! An oversize hole will prevent switch
installation and cannot be repaired in the field. The
divider panel must be replaced .
3. See Figure 7. Insert switch into hole.
Figure 7 - Switch Installed on Divider Panel
x
x
1.5 in
(3.81 cm)
3 in
(7.6 cm)
2 in.
(5.1 cm)
5 in.
(12.7 cm)