Manual

"11
r--
r--
2013 EVOLUTION/SYNC2.0 HSB MENU MAP
Running Manual
Runnk_g-Utilfiy Lost
Running-Remote Start
Running-2 Wire Start
Running - Exercise
Switched Off
Stopped - Auto
Stopped - Alarm
Battery Condition
"Good" 'Inspect Battery" or "Check Battery"
_ENTE_
- 1 thru 50 + - Run Log +
ESC ..-I1_
- 1 thru 50 + - Alarm Log +
Warning Message(s)
"Low Battery"
"Exercise Set Error"
"FIRMWARE ERROR-9"
"Fuel Pressure"
"Battery Problem"
"Charger Warning"
"Charger Missing AC"
"Overload Warnk_"
"Overload Cooldown"
"SEEPROM ABUSE"
"USB Warning"
"Download Failure"
/
.... Language_Language_Language_Language
÷ English ÷ + English - + Espanol - + Francais -
- ESC
Fuel Selection Fuel Selection
ESC
÷ NGorLP÷ + NGorLP-
Switched to "OFF" Current Date/Time
Hours o0f _H_tection
ESC 02/14/13 07:40
__ ---_Ar_ ....
ENTE""""""_ _ _ Access Requires Password
H Language /
+ Po_uguese -
z:a _ /F._ MANU.II./,:::aOR = x uP ARROW = +
DOWN ARROW = -
Run Hours (H)
00 /
ENTER ESC- + EXAMPLE:
Inspect Battery 200 RnHr or 12/27/13
and
Next Maintenance 200 RnHr or 12/27/13
I
Alarm Message(s)
"High Engine Temp."
"Low Oil Pressure"
"Overcrank"
"Overspeed"
"RPM Sense Loss"
"Underspeed"
"Internal Fault"
"FIRMWARE ERRQR-T'
"WIRING ERROR"
"Over Voltage"
"Under Vokage"
"Ovedoad Remove Load"
"Low Volts Remove Load"
"Stepper Over Current"
"Fuse Problem"
0198170GST-D 05/22/13
Page 1 of 4
I i,,c l,,Cl = l,,c l,,c l,,c ....
ESC _| ÷Current2/12/13Date/Time12:22÷ ENTER _ Sefect_ Hour14+(0-23) Select_ Mino +(0-59) Select Month_2 + (1-12) Select_ Date13 +(1-31 ) Select_ Year13+(0-99)
;t t tE tE t /
....
ESC _| Exercise Time Quiet Test Mode ? Select Hour (0-23) Select Min (o-5g) Select Day÷ 14:00Wednesday ÷ - YESorNO + - 14 + - 0 + - Wednesday +
Select "Yes" then Press "Enter" to continue or Press
_ f Quiet Test Mode only
on certain models "ESCAPE" to escape out of updating.
Possible Message(s) Durh_g update process the Blue "Manuar r light fiashesr then
_ _ _... the Green "Auto" light flashes. Seq does this twice.......
FM]lware Update Firmware Update Corrupted Fife "Current:V XXXX .... Are You Sure?" When update is complete the unit returns to Install Wizard
• 1_ ESC Invalid File
÷ Press Enter ÷ ÷ Insert USB ÷ File Not Found "USB: V XXXX .... - Yes or No +" menu.
Unsupported Device When the controller powers up the very first screen displays
the version number for a few secot_ds.
When update is complete remove Thumb Ddve, then follow
the Install Wizard Menu.