Manual

Section 3
3.1 -- Control Panel
Operation
Interface
//_ The control panel on this unit is intended to only be operated by qualified service personnel.
The Control panel interface is located under the lid of the enclosure. Before attempting to lift the lid of the enclosure, verify that both left and right
side locks are unlocked. To remove the front cover, lift the cover straight up to disengage the side hooks, then tilt and lift it away from the unit.
When closing the unit, ensure that both left and right side locks are securely locked. See Figure 3-1.
The enclosed keys provided with this unitare for service personnel usage only.
SIDE LOCK
Figure 3-1" Generator With Lid Open/Side Lock Location
Set to AUTO, the engine may crank and start at any time without warning. Such automatic starting
occurs when utility powersource voltage drops below a preset level or during the normal exercise
cycle. To prevent possible injury that might be caused by such sudden starts, always set to OFF and
remove the fuses before working on or around the generator or transfer switch. Then, place a "DO
NOT OPERATE" tag on the generator panel and on the transfer switch.
NOTE:Thegeneratoristoberunwithallappropriatepanelsin place,includingduringtroubleshootingbya technician.
Automatic Standby Generator Owner's Manual 11