Manual
.
Attach siphontube to location A (Figure5).
Figure 5 - Siphon TubeLocation
.===_
ADDFUEL
Fuelmust meettheserequirements:
* Clean,fresh, unleadedgasoline.
* A minimum of 87 octane/87AKI (91 RON).
* Gasolinewith up to 10% ethanol (gasohol)is acceptable.
NOTE:
Avoid powerwasherdamage. Failureto follow Operator's
Manualfor fuel recommendationsvoidswarranty.
* DO NOTuse unapprovedgasoline such as E85.
* DO NOTmix oil in gasoline.
* DO NOTmodify engineto run on alternatefuels.
Toprotectthe fuel systemfrom gelling,mix in afuel stabilizerwhen
addingfuel. SeeStorage.All fuel is not the same.If you experience
starting or performance problems after using fuel, switch to a
differentfuel provider or change brands.
ADDENGINEOIL
1. Place powerwasher on a flat, level surface.
2. Clean area around oil fill and remove orange oil fill cap/
dipstick.
3. Usingoilfunnel (optional),slowly pouroil into fill opening.See
Maintenancesection for oil type recommendation.
NOTE:
Onsomeunits there ismorethan one oil fill location,in these
instancesitis only necessaryto use one of theoil fill points.
4. Check periodicallyuntil the oil levelis between"L" and "H"on
the dipstick (Figure6). DONOTOVERFILL.
Figure6 - Dipstick
Acceptable Oil
Level Range
Fuel and itsvaporsare extremelyflammable
and explosive.Fire or explosion cancause
severe burns or death.
WHEN ADDING FUEL
* Turn power washer OFFand let it cool at least two (2) minutes
before removingfuel cap. Loosen cap slowly to relievepressurein
tank.
* Fillfuel tank outdoors.
* DONOToverfill tank. Allow spacefor fuel expansion.
* If fuel spills, wait until it evaporatesbefore starting engine.
* Keepfuel away from sparks, open flames, pilot lights, heat, and
other ignition sources.
* DONOTlight a cigarette or smoke.
1. Clean area around fuel fill cap, remove cap.
2. Slowly add regular unleaded fuel to fuel tank. Be careful not
to overfill. Fill to bottom of filter screen, this will allow for fuel
expansion (Figure 7).
3. Install fuel cap and let any spilled fuel evaporate before
starting engine.
Figure 7- Adding Fuel
NOTE:
Any attempt to crankor start the engine before it has been
properlyserviced with the recommendoil may resultin engine
failure.
5. Replaceoil fill cap/dipstickandfully tighten.
/










