Manual

.
Move throttle control lever to "HIGH" position, shown on
engineas a rabbit (Figure25).
Figure 25 - Thrott/e Contro/
Figure27- Starting the Engine
Starter Handle
High Low
.
Turnthe engineswitch to the "ON"position (Figure26).
Figure26 - TheONPosition
IMPORTANT:Beforestarting the power washer, be sure you are
wearing adequatesafetygoggles.
.
6.
Riskof eye injury.Spray cansplashbackor propel
objects.
* Alwayswear safetygoggleswhen usingthis equipmentor in
vicinityof equipmentin use.
* Beforestarting the power washer,be sure you are wearing
adequatesafetygoggles.
* NEVERsubstitutesafetyglassesfor safetygoggles.
Placefoot onfootpador otherwise secureunit from movement
when pulling recoil.
When starting the engine, grasp starter grip handle (Figure
27) and pull slowly until you feel some resistance.Then pull
rapidly to start engine.
Starter cordkickback(rapid retraction)can resultin
,_. bodilyinjury.Kickbackwill pullhandand arm toward
engine faster thanyoucan let go. Brokenbones,
fractures,bruises,or sprainscouldresult.
* NEVERpullstartercordwithoutfirstrelievingspraygunpressure.
* Whenstartingengine,pullcord slowlyuntil resistanceis felt and
thenpullrapidlyto avoidkickback.
* Aftereachstartingattempt,whereenginefailsto run,alwayspoint
sprayguninsafedirectionandsqueezesprayguntriggerto release
highpressure.
* Firmlygraspspraygunwithbothhandswhenusinghighpressure
sprayto avoidinjurywhenspraygunkicksback.
7. Returnstarter grip handleslowly.DONOTlet rope"snapback"
againststarter.
8. When engine starts, slowly move choke lever to "OPEN"
position as enginewarms. If enginefalters, move chokelever
to "CLOSE"position,then to "OPEN"position (Figure28).
Figure28 - Choke Lever
Choke
9. After each starting attempt, where enginefails to run, always
point gun in safe direction, and squeezespray gun trigger to
releasehigh pressure.
10. If engine fails to start after six pulls, move choke lever to
"OPEN"position,and repeatsteps 6 through 10.
13